Mashed malted scald rye buckwheat sourdough baguettes 

Mashed malted scald rye buckwheat sourdough baguettes 

Borrowing Mashing from Beer Brewers

In the last two weeks, I’ve played with “mashing” malted rye and buckwheat to produce a sweet scald for my baguettes. Mash is a term used by beer brewers when they add enzymes to their grains and keep them hot over time to break the starches down into sugars. My mash blended buckwheat flour, diastatic malted rye flour, and hot water, and kept it at 55 celcius for 20 hours. 55 celcius was the best my proofing box could do, and was also a good temperature to keep amylase enzymes active and not destroy them.

 

Malting Rye Kernels at Home

I made the malted rye myself by sprouting rye kernels, malting them (waiting for sprouts to grow to the length of the kernels), drying them with a dehydrator, then milling them into a flour. I also created a proofing box to maintain the 55 celcius. I used pink foam insulation, duct tape, and the dehydrator head with the heater and fan.

 

100g rye kernels malted (sprouted in 12hrs, malted in 36hrs)

 

Dehydrated malted rye kernels… I weighed them after dehydration to check that they weighed 100g again.

 

 

Preparing the Mash

Dark buckwheat flour, fresh milled rye flour, and rye malt with hot water added. The first time I used this technique, my ratio was 2:1 water to flour, which resulted in more of a slurry. The second time was 1.5:1 water to flour, which resulted in more of a porridge.

 

My DIY mashing box. The dehydrator top supplies hot air around its edges and has a fan in the middle that pulls air up to circulate. The little door in the front lets me see an oven thermometer inside.

 

 

After 20 hrs the malted mash was creamy and reddish.

 

 

The first time I mashed, the sweet aroma of buckwheat honey surprised me when I checked the mash at 12 hours and again after 20 hours. The consistency shifted from water, to white and creamy, to red and creamy. On my second try, I used less water and was amazed at the fluffy texture of the resulting porridge with aromas of buckwheat honey, apples and tahini, and with a similar shift in colour from white to red.

 

Put on the breaks: Denaturing the Enzymes in the Mash

To denature the amylase enzymes from the malted rye (and prevent a starch attack… meaning, the enzymes destroying the starch in the dough when the mash was mixed in) I heated the mash on the stove and it quickly transformed into a dark red roux-like paste. This gelatinization will also compensate for low/no gluten in the rye and buckwheat flours. Some of it caught on the bottom… but after a day in the fridge that part easily came off and tasted almost chocolatey. 

 

 

Making the Dough

When making the dough, mixing the autolyse, levain and porridge was a bit of a challenge. The second time produced a fluffy kind of porridge that took quite a beating in the mixer before it pulled away from the bowl.

 

Here are the three pieces of the dough: autolysed AP flour, 100% hydration rye starter, and the dark rye-buckwheat mash. AP was 70%, milled rye 15%, dark buckwheat 15%. 

 

 

After extensive mixing (7 mins + 15 min rest x 3 times) the dough had transformed from fluffy porridge into a stickier dough. The bowl was warm from the mixing so I cooled it with a cold pack. I put the final dough in the fridge for an overnight retarded fermentation.

 

 

Loaves From Low to Higher

I shaped my loaves as baguettes and it was a sticky dough. My first loaves were overproofed and a bit flat. But they still had an aerated crumb and delicious depth of flavour that delighted me. Initially not long from the oven, it tasted almost sweet and spicy like gingerbread. Ugly but tasty. I lost my jar of malted rye flour in a sad kitchen mishap, but the flavour of the bread over the following week inspired me to go through the whole process of sprouting, malting, drying and milling rye kernels a second time.

 

Here’s my first bake. The overproofing was my fault… I zoned out on the couch. I was doing the poke test periodically but with so much porridge in the dough, I don’t think it works well. Yes they were reddish brown… an effect of the diastatic rye malt enzymes freeing up sugar for browning.

 

 

My second set of loaves were also ugly, but twice the volume of the first try. My second try used less water in the porridge and also bumped my levain back up from 100g to its usual 130g. I also returned to my usual proofing time. 

 

Both sets of loaves had holes in their crust, indicating a breakdown of dough strength. Apparently sourdough acidity can protect against starch attack by amylase… (thanks calbeach!) so I will use that more deliberately next time.

 

 

Taste and Texture

Tasting notes to come following lunch today.

Had it toasted… light, crispy crust, creamy soft chew, and a sweet flavour with hints of spice and apple. Wow, very cool.

Next steps… I’ve ordered a few more kilos of rye kernels. There is so much potential in rye… so many flavours you can get out of it. I want to increase my rye amounts and shift more of my AP into fresh-milled wheat, farro or spelt. I’d also like to try more kinds of rye preparation, as per the Rye Baker’s multi-stage recipes.